After much anticipation the new Shrockworks full width rear bumper / tire carrier arrived. Very well packaged. Installation was not too bad but an extra set of hands is nice to have.

This will not be much of a "how to" :teacher: due to not having a decent camera available, all I had was my phone so just before / after pics. :agreed:

The instructions had quite a few holes, most of it was there but there could have been a few more details in order to avoid some aggravation.

The bumper install was very simple - getting the old one off was as easy as removing the small handful of mounting bolts and tossing that POS to the curb. You will also need to remove the stock mounting bracket. The instructions for the bumper install were very easy to follow. You have to install the lights before you mount the bumper or you will have to take it off in order to get to them. There is also a square bushing that sits under the latch that is best installed before mounting the bumper for the same reason as the lights.

Mounting the tire swing was very simple. I gave everything some red threadlock and managed to get a bunch on myself as usual....

The part that was a PITA was the jerry can mounts and rubi rack. There were no instructions for the rack but easy enough to figure out with a little thinking. One point of advice would be to get all the bolts started but don't tighten anything to make sure that you can align everything and in case you need to move something. If you are going to only use the jerry can mounts then you can use any of the holes on the diagonal beams, making a tight fit against the tire. If you are going to use the rubi rack then the jerry can mounts must go in the lower most holes. Added some threadlock to all the bolts on the can mounts and rubi rack as well.

Another thing to note is that this thing is very heavy. The bumper/swing is about 200#, add in the wheel and tire (17" 35s), the can mounts and rubi rack are another 50# then add in the jerry cans and fuel, Hi-Lift... then whatever you put in the rubi rack. Not sure how much lift I will lose due to droop... we shall see.

Shrock gets an A+ for design and quality, worth the wait. The instructions get a C....

Before:


After:

Nice. It's like your Jeep's ass grew half another Jeep

What top is that you've got there?

That looks BAD ASS

Looks good, let me know if you still want to get rid of your old LP bracket?

fugging AWESOME RG! I'm jealous now!!!

Dat beeotch needs to be down at da coast!!! Sweet man!!!

Looks great

Wired up the 3rd brake light / license plate light, wired up the CB antenna and found a way to move the HiLift over to where it was not blocking the tail light.
Just gotta put some gas in the cans and get some locks to keep everything where it should be.

I wanted to add a few more cool little details about the setup.
Everything can be locked to prevent theft. I found a nice set of Master Locks
that are weather resistant and have a no-rust guarantee, nice if they
are going to be out in the weather all the time. I had to drill out the
holes in the can holders a little bit and put several coats of paint in
the holes to prevent rust.

Looks great Ron! It seems like ages ago when you decided on that bumper at Hooters!

that looks tough. let a grocery getter rear end you and see what happens

If they haven't figured it out by now, they aren't going to. I hate to knock on those guys, but their production planning out right sucks and has for the better part of two years.

looks awesome

That is one beautiful set-up, you made us all jealous!!!

that is one bad ass bumper. how much does that massive setup weigh ???
if i only had some extra cash laying around....