OK folks.... this is hands down the easiest install that I have seen (besides the dimple mod from unstrapping the door and perhaps the Daystar dash panel).

I have been worried about the evap canister because it is about the only thing that is not protected under the heap...


I had to laugh at myself a little when I dug around the box for the install instructions.... then I looked at the skid and saw there are only three bolts... all very easy to get to. Simply remove the three bolts:



And slide the skid over the evap assembly


The one thing that I did see may be an issue was the wiring plug would be in a bind if it was just bolted up. Easy fix was to unplug it and route it inside the bracket:



Then bolt it back up.... I did put some red thread-lock on the bolts while I had them out:


Protected and peace of mind! Easy fix and a good price from [URL="http://www.benchmark-designs.com/products_evap_canister_skid.php"]Benchmark Designs[/URL] right now.

Nice!!! I bought one a couple of days ago. I will put mine on tomorrow. Thanks for the write up.

Nice, thats the way a Jeep should come from the factory if the can't find a better place for that thing.